prima_control:target_control
This is an old revision of the document!
Table of Contents
Target control
Change target
- beam off
- move target
- beam on with desired current → ELOG entry
Target camera
The app for the target camera is on the PC on front of the racks (a1analyse).
The camera should only be turned on when the beam is off or to look at the beam position on the luminescent screen (Al203).
A blue window is open (“MPlayer”). Click on it and press “c” to turn the camera on or off.
When the beam is positioned on the luminescent screen take a photo: press “p”; this automatically generates an ELOG entry in the A1 ELOG (open on the same computer).
Move Target
- beam off
- go to computer control1
- find a terminal “mezzo”
- move target with “go_target”
- check target position with “where_target”
- for optimization in A1 hall: empty target
List of targets and commands:
| Target | command |
|---|---|
| empty | go_Empty |
| Pb nat (124µm) | go_Pb124mu |
| Plastic (Lupolen) | go_CH2 |
| Si28 | go_Si28 |
| Pb nat (200µm) | go_Pb |
| luminescent screen | go_Al203 |
| Ta181 | go_Ta181 |
| C12 | go_C12 |
| holy carbon | go_holyCarbon |
prima_control/target_control.1740651314.txt.gz · Last modified: 2025/02/27 10:15 by himuser