prima_control:mami_optimization
This is an old revision of the document!
MAMI needs optimization
- Beam off → ELOG entry “beam off, MAMI optimization, maybe reason”
- HV off (How to ramp the high voltage)
- Change target to “Empty” (Target control)
- Now MAMI can start the optimization → call MAMI
- when the optimization is finished, normally <1h (call from MAMI): check beam position (Target control)
- change target to luminescent screen (Al203)
- turn on target camera
- turn on beam slowly (MAMI) until you see a white spot
- ask MAMI to center the beam
- take a picture
- turn beam off
- now you can move to the desired target (Target control)
- turn HV back on (How to ramp the high voltage)
- turn beam on with the desired current → ELOG entry “beam on, target XY, current XY”
prima_control/mami_optimization.1740651630.txt.gz · Last modified: 2025/02/27 10:20 by himuser