prima_control:how_to_ramp_hv
This is an old revision of the document!
How to ramp the high voltage
in workspace “Apfel+HV” find terminal Ramp HV:
ramp Detector HV up:
agmaas@prima-daq1:~/repo/hv_control$ python3 ramp_hv.py -f /data/data_raid/prima_feb_25/hv_scan_6 -x /home/agmaas/Data/beamtime_Feb2025/hv/exclude_channels.dat -id all -off -0
ramp Detector HV down:
- <p>test</p><p>
agmaas@prima-daq1:~/repo/hv_control$ python3 ramp_hv.py -val 0 -x /home/agmaas/Data/beamtime_Feb2025/hv/exclude_channels.dat -id all
</p>
if the last line of the output is a 1 repeatedly, you can stop the terminal “Crt+c”
ramp pre-HV (ISEG) down or up:
- MAKE SURE DETEKTOR HV IS OFF!
- Go to webinterface→detector control → iseg high voltage (tab should be open in firefox already)
- select the 5 rightmost modules one by one
- Click checkbox “select all”
- click “switch all <on/off>”
prima_control/how_to_ramp_hv.1740737497.txt.gz · Last modified: 2025/02/28 10:11 by himuser