hitdetection:starting_the_chip
This is an old revision of the document!
Starting the ASIC Chip
The steps necessary to launch the ASIC chip are described here.
*title*
Starting at the HadanaPC3, connect to the DEPC002, and from there to the rio4-1:
agmaas@hadanapc3:~$ ssh mbsdaq@10.106.11.18 mbsdaq@depc002:~$ ssh rio4-1
Now (we) open the folder hit_mainz/, where the folders HitDetection2Cmd/ and HitDetectionMBS/ are:
RIO4-1 mbsdaq > cd hit_mainz/
FPGA as clock
Next you need to start the clock for the ASIC chip. A FPGA-board is used as the clock. To turn on the FPGA-board, flip the switch on the front right side of the board. The FPGA-board is programmed from the HadanaPC4. There will be in the Folder /home/agmass/KCU105/lvds_clk a lvds_clk.xpr file.
agmaas@hadanapc4:~$ cd KCU105/ agmaas@hadanapc4:~ /KCU105 ls agmaas@hadanapc4:~ /KCU105 cd lvds_clk agmaas@hadanapc4:~ /KCU105/lvds_clk$ vivado18
This will start the GUI to operate the FPGA.
Now in the bottom left open the hardware manager and open “target” in the top middle (and press auto connect)
hitdetection/starting_the_chip.1583160171.txt.gz · Last modified: (external edit)