The goal is to have a fully equipped and running detector in A1 at October 18th.

To do in HIM hall:

• [x] Cable the detector (P, C, S, Aj) (30.08.)
• [x] detector submodule position measurement (P+C+S) (06.09.)
• [ ] leakage test, humidity test at room temperature or 10 deg (J+P) (06.09.)
• [ ] splitter board test (L) (06.09.)
• [ ] VLAN commissioning (O) (06.09.)
• [x] assemble SADC setup (O+A) (13.09.)
• [ ] read out whole detector at once (13.09.)
• [ ] cosmic measurement 200MeV; warm or cold? (13.09.)
• [ ] Get cabled detector ready for movement (16.09.)

Time plan in A1-hall:

• [x] Move spectrometers (30.08.)
• [x] Clear stuff in A1 hall (S) (30.08.)
• [x] Disassemble exit beam pipe (29.08. 10 o'clock)
• [x] Disassemble target chamber (06.09.)
• [x] Build, install and measure target ladder
• [x] install new target chamber
• [ ] Build MayTech table in A1-Hall (10.09.)
• [ ] Move calorimeter to A1-Hall (17.09.)
• [ ] Close target chamber and vacuum test (20.09.)
• [ ] Install calorimeter (17.09.)
• [ ] Align and measure calorimeter (20.09.)
• [ ] Install exit beam pipe (04.10.)
• [ ] Vacuum test of exit beampipe
• [ ] Install infrastructure (PC, Racks, etc.) (04.10.)
• [ ] Cable calorimeter on Rack side (04.10.)
• [ ] Test all submodules (11.10.)
• [ ] Put vacuum on exit beampipe for beamtime (18.10.)
• [ ] Cool detector (18.10.)
• [ ] Cosmic measurement, 25 MeV, cold

Cooling (J):

• [ ] connect outer cooling (06.09.)
• [x] prepare manifold boxes
• [ ] humidity readout

Parts Missing:

• temperature cables external
• adapter plates for table (feet, rails, etc.)
• “Belegbretter” for table
• finish flange for exit beam pipe downstream
• central alignment piece for calorimeter