• Stecker
• Low Voltage
• High Voltage
• APFEL Control

• Light Pulser 1 (Mainz)
• Light Pulser 2 (LED Matrix)
• Chiller???

• go to hadanapc2
• go to /home/beamtime22/
• make sure, vxi11 is executable. if not do so with $ sudo chmod +x vxi11
• run BEAMTIME22_temperature_standalone.py which requires >python2.7 and no additional package
• in the script, you can adjust the TIMEOUT = 120, which is the waiting time between measurement cycles and IP = “192.168.10.14”, which is the ip address of the Keysight module
• the last measurement is always print out in the console.
• the data for the upper and lower proto are saved in seperate files in the same directory.
• the time stamp is the standard unix one

start server on VME PC:

• got to VME-PC $ ssh 192. 168.10.11
• $ cd ~/GEM_Proto/HV/WebHV/
• $ ./SYMBhv -c HVconfig_CFD.conf

open a new terminal and start the GUI on hadanapc5:

• $ cd ~/VME/HV_CAEN/build-HVgui
• $ ./HVgui

Now the GUI window opens. Channel 2 and 3 are currently used for the scintillators. Set the trip current to 30 muA and set the max Voltage to 1500 V. Turn up the voltage to 1300 V, now you should be able to see signals.

• on VME PC: cd QDC_v965“ * ./qdc_readout === Scaler === start Scaler on VME PC: * got to VME-PC $ ssh 192. 168.10.11 * $ cd ~/Scaler_1000mus/src * $ ./scaler <number of channels> <Dwell time [s]> * the rate for the channels is written in ~/Scaler_1000mus/output/rate.txt. This file is rewritten every time, so this is not meant for storing the data! === CFD === also on VME PC: * got to VME-PC $ ssh 192. 168.10.11 * $ cd ~/CFD * $ ./cfd_control''
• the CFD contrl reads the thresholds from the config.txt