====== A1 control ======

==== Change Target ====
  * Make sure the beam is off! Usually one moves the target only while being on the phone to MAMI.
  * Open a terminal as mezzo on control1
  * Optional: Check the target position with ''where_target''
  * Go to the new position with the appropriate go-command (e.g. ''go_C12'')
  * Check the target position with ''where_target''. The setpoint should be the selected target, and the difference should be small ( < 100 )


=== Checking Beam Position ===
  * Call MAMI and tell them, that you want to check the beam position.
  * **Ask MAMI to switch off the beam and wait for the confirmation, that the beam is off!**
  * Move in the screen (see section: **Change Target**) ''go_Al2O3''
  * on a1analyse (Computer with Dual screen) locate the upwards arrow on the panel next to the a1-logo
    * Click it to open the menu
    * Select the menu item ''Target Camera''
    * An MPlayer window will open. If not, check if it's already open.
  * Press ''c'' to activate the camera, now you should see the cross hairs on the screen.
  * Ask MAMI for a little bit of beam (nanoamperes)
  * When you see the beam on the screen, take a picture by pressing ''p''. It will be saved to the logbook.
  * Ask MAMI to center the beam on the target and take another picture.
  * **Switch off the camera** by pressing ''c'' again. Close the MPlayer window.
  * **Ask MAMI to switch off the beam and wait for the confirmation, that the beam is off!**
  * Move in the correct production target (e.g. ''go_C12'')
  * Wait for the target to reach the position.
  * Check the target position with ''where_target''. The setpoint should be the selected target, and the difference should be small ( < 100 ).
  * Ask MAMI for the correct beam current.

==== Spec A ====

==== Spec B ====