software:g4simulation:configuration
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
software:g4simulation:configuration [2020/11/09 09:52] – himuser | software:g4simulation:configuration [2022/01/14 18:44] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 19: | Line 19: | ||
geometry-file < | geometry-file < | ||
</ | </ | ||
+ | | ||
+ | | ||
+ | * Specify if the tagger/ | ||
+ | use-tagger <0/1> | ||
+ | </ | ||
+ | * Specify if the clorimeter is used as sensiteve detector (SD): < | ||
+ | use-clorimeter <0/1> | ||
+ | </ | ||
+ | |||
+ | * Specify if radiation studie should be done: < | ||
+ | do-radiation-studies <0/1> | ||
+ | </ | ||
* Specify the geant4 macro file to be executed. If this command is not used the geant4 interactive shell will be loaded. < | * Specify the geant4 macro file to be executed. If this command is not used the geant4 interactive shell will be loaded. < | ||
Line 36: | Line 48: | ||
* '' | * '' | ||
* '' | * '' | ||
- | * '' | + | * '' |
- | * '' | + | * '' |
+ | * '' | ||
\\ | \\ | ||
- | * Explicit config Parameters for " | ||
- | * set velocity direction, leave dz = 1200 to hit the detectors surface at dx, dy < | ||
- | #Pi0_dx 200 | ||
- | #Pi0_dy 200 | ||
- | #Pi0_dz 1200 | ||
- | </ | ||
- | * set the particles initial energy < | ||
- | Pi0_Emin 1000 | ||
- | Pi0_Emax 1000 | ||
- | </ | ||
- | * it is also possible to choose the velocity direction by setting the polar angle (that is the angle to the z-axis) of the initial pion, the anzimuth angle is randomly distributed between 0 and 2 pi < | ||
- | Pi_theta 5 </ | ||
- | \\ | ||
- | * Specify if the tagger/ | ||
- | use-tagger <0/1> | ||
- | </ | ||
- | * If there is no scintillator in the geometry, use-tagger needs to be set 0 |
software/g4simulation/configuration.1604915576.txt.gz · Last modified: 2022/01/14 18:44 (external edit)