Differences

This shows you the differences between two versions of the page.

--- software:g4simulation:configuration [2019/08/05 12:27] – himuser
+++ software:g4simulation:configuration [2022/01/14 18:44] (current) – external edit 127.0.0.1
@@ Line 19: / Line 19: @@
 geometry-file <filename>
 </code>
+  * Specify if the tagger/scintillator is used as sensiteve detector (SD):    <code>
+use-tagger <0/1>
+</code> If there is no scintillator in the geometry, use-tagger needs to be set 0
+  * Specify if the clorimeter is used as sensiteve detector (SD):    <code>
+use-clorimeter <0/1>
+</code>
+  * Specify if radiation studie should be done:    <code>
+do-radiation-studies <0/1>
+</code>
   * Specify the geant4 macro file to be executed. If this command is not used the geant4 interactive shell will be loaded. <code>
@@ Line 36: / Line 48: @@
     * ''particleGun'': uses the geant4 particle gun which can be set in the macro file
     * ''p16uniform'': generates electron over the surface of proto16, placed at 1.2 m from the particle source. The electron energy is uniformly distributed between 100 MeV and 1500 MeV
+    *  ''primaUniform'': generates electrons over the surface of the PRIMA detector (between Rin and Rmin [mm]), placed at 1200 mm (=dz) from the particle source. The electron energy is uniformly distributed between Emin and Emax [MeV].
+    *  ''pi0Gun'': generates a pion with arbitrary directon, origin 1.2 m from detector (z-direction). The particles energy is uniformly distributed between Emin and Emax. If Emin = Emax, the particles have a constant initial energy. The pion instantly decays into two photons with random momentum directions constrained by momentum conservation. Also the angles of the pion can be chosen (theta, phiMin, phiMax [deg]).
+    *  ''beam'': shoots electrons in z-direction, is positioned a view mm before the target and has to be used with a geometry which includes the target!
+\\
-  * Specify if the tagger/scintillator is used as sensiteve detector (SD):    <code>
-use-tagger <0/1>
-</code>