Differences

This shows you the differences between two versions of the page.

--- software:g4simulation:config_commands [2019/02/15 16:22] – himuser
+++ software:g4simulation:config_commands [2019/02/15 16:42] (current) – removed himuser
@@ Line 1: / Line 1: @@
-  * Specify the root file where the geometry (''TGeoManager'' object) to be used in the simulation is saved.     <code>
-geometry-file <filename>
-</code>
-  * Specify the geant4 macro file to be executed. If this command is not used the geant4 interactive shell will be loaded. <code>
-macro-file <geant4 macro file>
-</code>
-  * Specify the root file where the simulation output is written. **Attention!** The specified file will be overwritten.<code>
-root-output-file test_bwec.root
-</code>
-  * Specify the primary generator to be used <code>
-primary-generator <generator>
-</code> Until now, the following options are available:
-    * ''particleGun'': uses the geant4 particle gun which can be set in the macro file
-    * ''p16uniform'': generates electron over the surface of proto16, placed at 1.2 m from the particle source. The electron energy is uniformly distributed between 100 MeV and 1500 MeV