Differences

This shows you the differences between two versions of the page.

--- sideprojects:cloudchamber:notes [2018/02/09 15:42] – created himuser
+++ sideprojects:cloudchamber:notes [2022/01/14 18:44] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
   * Check Maytec profiles (40-50); center holes for screws
-  * Check plastic caps for the Maytec profile counterboard holes in the plastic
+  * Check plastic caps for the Maytec profile counterbored holes in the plastic
+  * 2 mm extra on both sides of the glass channels. depth? ask vacuum workshop
+  * radius pocket insulation of the plastic
+  * o-ring size?
+  * in general corners: sharp 90 or round?
+  * Holes in plastic to maytec in the corners are wrong
+  * plastic plate bigger, so the maytec profiles don't make uncomfortable to work with the led cooling/system
+  * study the possibility of making outer glass bigger, to easy the led cooling/system. it doesn't fit
+  * check proper dimension of led pcb. Connector. ratio cables/leds. dimensions as they are
+  * copper pipe above or below the plastic plate?
+  * collector with round shape? yes, except where the archimedes is
+  *
+  *
+  * screws from brass plate to alu plate
+  * collectdor isopropanol, next to alu plate
+  * luzius, archimedes, stainless steel, bending, dimensioning
+  * check if we can cut out a corner of brass plate for space for archimedes
+  * leave the cooling pipe above the plastic plate and cover it
   *