hitdetection:starting_the_chip
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| hitdetection:starting_the_chip [2020/03/02 16:04] – himuser | hitdetection:starting_the_chip [2022/01/14 19:44] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ======Starting the ASIC Chip====== | ======Starting the ASIC Chip====== | ||
| The steps necessary to launch the ASIC chip are described here. | The steps necessary to launch the ASIC chip are described here. | ||
| - | ===*title*=== | + | |
| Starting at the HadanaPC3, connect to the DEPC002, and from there to the rio4-1: | Starting at the HadanaPC3, connect to the DEPC002, and from there to the rio4-1: | ||
| Line 23: | Line 23: | ||
| | | ||
| - | This will start the GUI to operate the FPGA. | + | This will start the GUI to operate the FPGA. Select directly or first navigate to the lvds_clk project and open it. |
| - | Now in the bottom left open the hardware manager and open " | + | Now in the bottom left open the hardware manager and open " |
| If the xcku040_0 shows "not connected", | If the xcku040_0 shows "not connected", | ||
| Line 33: | Line 33: | ||
| | | ||
| - | In the terminal in the bottom left execute the last command. This will start the GUI for the measurements. | + | In the terminal in the bottom left execute the last command. This will start the GUI for the measurements: |
| + | | ||
| + | | ||
| + | | ||
| + | | ||
| + | The link will be found here: | ||
| + | http:// | ||
| ===HitDetectionMBS=== | ===HitDetectionMBS=== | ||
| In the terminal where HitDetectionMBS/ | In the terminal where HitDetectionMBS/ | ||
hitdetection/starting_the_chip.1583161498.txt.gz · Last modified: (external edit)