hardware:alveolus_production
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| hardware:alveolus_production [2020/07/06 17:59] – created himuser | hardware:alveolus_production [2022/01/14 19:44] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| • For the unmoulding: | • For the unmoulding: | ||
| - | - Break the excess of resin on both ends | + | - Break the excess of resin on both ends |
| - | - Clean very well any rest of resin on the end of the mandrel (opposite to the cables end) | + | - Clean very well any rest of resin on the end of the mandrel (opposite to the cables end) |
| - | - Push the mandrels out | + | - Push the mandrels out |
| - | - If they get stuck use the plastic hammer | + | - If they get stuck use the plastic hammer |
| - | - Then you can use the second hammer to go further | + | - Then you can use the second hammer to go further |
| - | - If needed use the aluminium rods. Always protect the tip. Never hammer metal against metal. | + | - If needed use the aluminium rods. Always protect the tip. Never hammer metal against metal. |
| - | - Never push a Mandrel on the top position without a mandrel below | + | - Never push a Mandrel on the top position without a mandrel below |
| - | - Use a Styrofoam piece to hold the alveolus in place when hammering | + | - Use a Styrofoam piece to hold the alveolus in place when hammering |
| - | - Always use cotton gloves and safety goggles | + | - Always use cotton gloves and safety goggles |
hardware/alveolus_production.1594051174.txt.gz · Last modified: (external edit)