Differences

This shows you the differences between two versions of the page.

--- beamtimes:2024:vme [2024/10/02 13:11] – himuser
+++ beamtimes:2024:vme [2024/10/14 12:44] (current) – [HV] himuser
@@ Line 3: / Line 3: @@
 ==== HV ====
+module location: 0xAAAA0000
 CAEN High Voltage (VME Crate) (negative high voltage):
@@ Line 8: / Line 9: @@
   -      ssh to vme crate: $ ssh vmepc
   -      agmaas@vmic1:~$ cd HV_CAEN/HV/WebHV/
-  -      start the programm on VME crate: agmaas@vmic1:~/GEM_Proto/HV/WebHV$ ./SYMBhv -c HVconfig_basel.conf (module location: 0xAAAA0000)
+  -      start the programm on VME crate: agmaas@vmic1:~/GEM_Proto/HV/WebHV$ ./SYMBhv -c HVconfig_basel.conf
 start the gui on hadanapc5:
+  - $ ssh hadanapc5
   - agmaas@hadanapc5:~$ cd ~/personal_dirs/sahra/beamtime24/vme/HV
   - $ source setEnv.sh
@@ Line 15: / Line 17: @@
   - $ ./HVgui
+You can save the channel configuration and labels. HV is not turned off, if the gui is closed.
 === CFD ===
+Module location: 0x00a00000
+Set the thresholds:
   - ssh to vme crate: $ ssh vmepc
   - agmaas@vmic1:~$ cd CFD
-  - start the programm on VME crate: agmaas@vmic1:~/CFD$ ./cfd_control (this generates a binary data)
+  - write the desired thresholds in the config: config.txt
-  - the binary can be converted to a txt file with: /home/agmaas/personal_dirs/sahra/beamtime24/vme/decode ($ ./decode data.bin data.txt) (Link zu /home/nagmaas/personal_dirs/luigi/vme/decode)
+  - set the thresholds: agmaas@vmic1:~/CFD$ ./cfd_control
+Threshold scan together with scaler:
+Scaler V775, Module location: 0x00CC0000
+  - start the scaler before doing the threshold scan:$ /home/agmaas/Scaler_1000mus/src/scaler 32 <dwell time [s]>"
+  - to start the threshold scan: agmaas@vmic1:~/CFD/threshold_scan$ ./threshold_scan <threshold interval [mV]> <points per threshold [int]> <dwell time [s]>