Differences

This shows you the differences between two versions of the page.

--- beamtimes:2024:vme [2024/10/02 09:47] – himuser
+++ beamtimes:2024:vme [2024/10/14 12:44] (current) – [HV] himuser
@@ Line 1: / Line 1: @@
 ====== VME PC ======
+IP: 192.168.10.11
 ==== HV ====
+module location: 0xAAAA0000
 CAEN High Voltage (VME Crate) (negative high voltage):
 start "server" on vme-pc:
-  -      ssh to vme crate: $ ssh 192.168.1.18
+  -      ssh to vme crate: $ ssh vmepc
-  -      agmaas@vmic1:~$ cd GEM_Proto/HV/WebHV/
+  -      agmaas@vmic1:~$ cd HV_CAEN/HV/WebHV/
   -      start the programm on VME crate: agmaas@vmic1:~/GEM_Proto/HV/WebHV$ ./SYMBhv -c HVconfig_basel.conf
-start the gui on gempc:
+start the gui on hadanapc5:
-  - agmaas@gempc:/home/lagmaas$ cd Gas_Detector/gem/Prototype/HV/build-HVgui-Desktop-Debug/
+  - $ ssh hadanapc5
+  - agmaas@hadanapc5:~$ cd ~/personal_dirs/sahra/beamtime24/vme/HV
+  - $ source setEnv.sh
+  - $ cd build-HVgui/
   - $ ./HVgui
+You can save the channel configuration and labels. HV is not turned off, if the gui is closed.
+=== CFD ===
+Module location: 0x00a00000
+Set the thresholds:
+  - ssh to vme crate: $ ssh vmepc
+  - agmaas@vmic1:~$ cd CFD
+  - write the desired thresholds in the config: config.txt
+  - set the thresholds: agmaas@vmic1:~/CFD$ ./cfd_control
+Threshold scan together with scaler:
+Scaler V775, Module location: 0x00CC0000
+  - start the scaler before doing the threshold scan:$ /home/agmaas/Scaler_1000mus/src/scaler 32 <dwell time [s]>"
+  - to start the threshold scan: agmaas@vmic1:~/CFD/threshold_scan$ ./threshold_scan <threshold interval [mV]> <points per threshold [int]> <dwell time [s]>