Differences

This shows you the differences between two versions of the page.

--- beamtimes:2024:target_control [2024/10/18 09:35] – created himuser
+++ beamtimes:2024:target_control [2025/03/06 12:13] (current) – himuser
@@ Line 1: / Line 1: @@
+===== MAMI needs optimization =====
+  - Beam off -> ELOG entry "beam off, MAMI optimization, maybe reason"
+  - Change target to "Empty"
+  - Now MAMI can start the optimization -> call MAMI
+  - when the optimization is finished, normally <1h (call from MAMI): check beam position\\
+    - change target to luminescent screen (Al203)
+    - turn on target camera
+    - turn on beam slowly (MAMI) until you see a white spot
+    - ask MAMI to center the beam
+    - take a picture
+    - turn beam off
+  - now you can move to the desired target
+  - turn beam on with the desired current -> ELOG entry "beam on, target XY, current XY"
 ====== Target control ======
+==== Change target ====
+  - beam off
+  - move target
+  - beam on with desired current -> ELOG entry
 ==== Target camera ====
@@ Line 13: / Line 36: @@
   * move target with "go_target"
   * check target position with "where_target"
+  * for optimization in A1 hall: empty target
 List of targets and commands:
 ^ Target              ^ command  ^
 | empty               | go_Empty      |
-| Pb nat              | go_Ca40       |
+| Pb nat (124µm)      | go_Pb124mu    |
 | Plastic (Lupolen)   | go_CH2        |
 | Si28                | go_Si28       |
-| Pb nat              | go_Pb         |
+| Pb nat (200µm)      | go_Pb         |
 | luminescent screen  | go_Al203      |
 | Ta181               | go_Ta181      |
-| C12                 | go_C40        |
+| C12                 | go_C12        |
 | holy carbon         | go_holyCarbon |
+== Target ladder control restart==
+if target ladder is not moving, restart the target ladder control:
+  $ ssh root@control5
+  $ /etc/init.d/mezzofe restart
+  $ exit