Differences

This shows you the differences between two versions of the page.

--- beamtimes:2022_apr:slow_control [2022/04/12 16:34] – [Scintillator] himuser
+++ beamtimes:2022_apr:slow_control [2022/04/21 12:02] (current) – himuser
@@ Line 12: / Line 12: @@
 === Temperature Readout ===
-  * go to hadanapc2
+  * ssh to hadanapc5
-  * go to /home/beamtime22/
+  * go to /DCS/Temperature/
-  * make sure, vxi11 is executable. if not do so with ''$ sudo chmod +x vxi11''
+  * make sure, vxi11 is an executable. Check with ''$ ls'', name of vxi11 should be green. If not, run ''$ sudo chmod +x vxi11''
-  * run BEAMTIME22_temperature_standalone.py which requires >python2.7 and no additional package
+  * run ''$ python3 main.py''
   * in the script, you can adjust the ''TIMEOUT = 120'', which is the waiting time between measurement cycles and ''IP = "192.168.10.14"'', which is the ip address of the Keysight module
   * the last measurement is always print out in the console.
-  * the data for the upper and lower proto are saved in seperate files in the same directory.
+  * the data for the different protos are saved in seperate files in a directory named after a unix timestamp
   * the time stamp is the standard unix one
+  * you can also read the temperature of the sensors without logging with ''$ python3 single_readout.py''
@@ Line 38: / Line 39: @@
 Turn up the voltage to 1300 V, now you should be able to see signals.
+=== CFD ===
-=== QDC ===
+also on VME PC:
-  * on VME PC: ''cd QDC_v965"
+  * ''$ cd ~/CFD''
-  * ''./qdc_readout''
+  * ''$ ./cfd_control''
+  * the CFD contrl reads the thresholds from the config.txt
 === Scaler ===
 start Scaler on VME PC:
-  * got to VME-PC ''$ ssh 192. 168.10.11''
   * ''$ cd ~/Scaler_1000mus/src''
   * ''$ ./scaler <number of channels> <Dwell time [s]>''
   * the rate for the channels is written in ''~/Scaler_1000mus/output/rate.txt''. This file is rewritten every time, so this is not meant for storing the data!
-=== CFD ===
+=== QDC ===
 also on VME PC:
-  * got to VME-PC ''$ ssh 192. 168.10.11''
+  * ''cd QDC_v965''
-  * ''$ cd ~/CFD''
+  * ''./qdc_readout''
-  * ''$ ./cfd_control''
+the QDC needs a gate to start measuring something!!
-  * the CFD contrl reads the thresholds from the config.txt