beamtimes:2022_apr:slow_control
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
beamtimes:2022_apr:slow_control [2022/04/12 15:27] – himuser | beamtimes:2022_apr:slow_control [2022/04/21 12:02] (current) – himuser | ||
---|---|---|---|
Line 9: | Line 9: | ||
* Light Pulser 1 (Mainz) | * Light Pulser 1 (Mainz) | ||
* Light Pulser 2 (LED Matrix) | * Light Pulser 2 (LED Matrix) | ||
- | * Temperature Readout | ||
* Chiller??? | * Chiller??? | ||
+ | |||
+ | === Temperature Readout === | ||
+ | * ssh to hadanapc5 | ||
+ | * go to / | ||
+ | * make sure, vxi11 is an executable. Check with '' | ||
+ | * run '' | ||
+ | * in the script, you can adjust the '' | ||
+ | * the last measurement is always print out in the console. | ||
+ | * the data for the different protos are saved in seperate files in a directory named after a unix timestamp | ||
+ | * the time stamp is the standard unix one | ||
+ | * you can also read the temperature of the sensors without logging with '' | ||
+ | |||
Line 24: | Line 35: | ||
* '' | * '' | ||
Now the GUI window opens. | Now the GUI window opens. | ||
- | Channel 2 is used for the scintillator. | + | Channel 2 and 3 are currently |
Set the trip current to 30 muA and set the max Voltage to 1500 V. | Set the trip current to 30 muA and set the max Voltage to 1500 V. | ||
Turn up the voltage to 1300 V, now you should be able to see signals. | Turn up the voltage to 1300 V, now you should be able to see signals. | ||
- | + | === CFD === | |
- | === QDC === | + | also on VME PC: |
+ | * '' | ||
+ | * '' | ||
+ | * the CFD contrl reads the thresholds from the config.txt | ||
=== Scaler === | === Scaler === | ||
start Scaler on VME PC: | start Scaler on VME PC: | ||
- | * got to VME-PC '' | ||
* '' | * '' | ||
- | * '' | + | * '' |
+ | * the rate for the channels is written in '' | ||
- | === CFD === | + | === QDC === |
also on VME PC: | also on VME PC: | ||
- | | + | * '' |
- | | + | * '' |
- | * '' | + | the QDC needs a gate to start measuring something!! |
- | | + | |
- | + | ||
- | === Temperature Readout === | + | |
- | * go to hadanapc2 | + | |
- | * go to / | + | |
- | * make sure, vxi11 is executable. if not do so with '' | + | |
- | * run BEAMTIME22_temperature_standalone.py which requires > | + | |
- | * in the script, you can adjust the '' | + | |
- | * the last measurement is always print out in the console. | + | |
- | * the data for the upper and lower proto are saved in seperate files in the same directory. | + | |
- | * the time stamp is the standard unix one | + | |
beamtimes/2022_apr/slow_control.1649777229.txt.gz · Last modified: 2022/04/12 15:27 by himuser