Differences

This shows you the differences between two versions of the page.

--- beamtimes:2022_apr:slow_control [2022/04/11 10:18] – himuser
+++ beamtimes:2022_apr:slow_control [2022/04/21 12:02] (current) – himuser
@@ Line 9: / Line 9: @@
   * Light Pulser 1 (Mainz)
   * Light Pulser 2 (LED Matrix)
-  * Temperature Readout
   * Chiller???
+=== Temperature Readout ===
+  * ssh to hadanapc5
+  * go to /DCS/Temperature/
+  * make sure, vxi11 is an executable. Check with ''$ ls'', name of vxi11 should be green. If not, run ''$ sudo chmod +x vxi11''
+  * run ''$ python3 main.py''
+  * in the script, you can adjust the ''TIMEOUT = 120'', which is the waiting time between measurement cycles and ''IP = "192.168.10.14"'', which is the ip address of the Keysight module
+  * the last measurement is always print out in the console.
+  * the data for the different protos are saved in seperate files in a directory named after a unix timestamp
+  * the time stamp is the standard unix one
+  * you can also read the temperature of the sensors without logging with ''$ python3 single_readout.py''
@@ Line 24: / Line 35: @@
   * ''$ ./HVgui''
 Now the GUI window opens.
-Channel 2 is used for the scintillator.
+Channel 2 and 3 are currently used for the scintillators.
 Set the trip current to 30 muA and set the max Voltage to 1500 V.
 Turn up the voltage to 1300 V, now you should be able to see signals.
+=== CFD ===
+also on VME PC:
+  * ''$ cd ~/CFD''
+  * ''$ ./cfd_control''
+  * the CFD contrl reads the thresholds from the config.txt
-== QDC ==
+=== Scaler ===
-== Scaler ==
 start Scaler on VME PC:
-  * got to VME-PC ''$ ssh 192. 168.10.11''
   * ''$ cd ~/Scaler_1000mus/src''
-  * ''$ ./scaler <number of channels> <dwell time [s]>''
+  * ''$ ./scaler <number of channels> <Dwell time [s]>''
+  * the rate for the channels is written in ''~/Scaler_1000mus/output/rate.txt''. This file is rewritten every time, so this is not meant for storing the data!
-== CFD ==
+=== QDC ===
 also on VME PC:
-  * got to VME-PC ''$ ssh 192. 168.10.11''
+  * ''cd QDC_v965''
-  * ''$ cd ~/CFD''
+  * ''./qdc_readout''
-  * ''$ ./cfd_control''
+the QDC needs a gate to start measuring something!!
-  * the CFD contrl reads the thresholds from the config.txt